Editing Mapping Groups
You can add and remove value pairs from a mapping group, but you cannot change the AccuWork or ITS values in a value pair individually: if you want to change an existing value pair, you must delete the pair and then create a new pair with the values you want. If you want to delete a mapping group, you must first delete all of its value pairs.
Note: Mapping groups are associated with transformers, which in turn are used by some field mappings. Because of this, changes you make to a mapping group might cause synchronization errors in any mapping definitions that rely on the field mappings that use a mapping group. To learn more about the relationship between field mappings, mapping groups, and transformers, see Creating a Mapping Group.
To edit a mapping group:
-
Go to the AccuSync Management Console main page.
Tip: Clicking the AccuSync logo at the top of any page takes you to the main page.
-
Click the Edit Configuration button .
The Configuration page appears.
-
Click the Edit Admin Details button.
The Admin Details for Configuration page appears.
-
To delete a mapping group, delete all of its mappings by clicking the Delete button for each.
-
To change the value for a value pair, delete the pair, and then add a new pair with the values you want.
After you make this change, you should run any synchronization patterns that use it to make sure that your changes provide the results you expect. See Running a Synchronization Pattern for more information.