Set Threshold Values Page (Goal Per Time Interval)
This wizard page enables you to set thresholds for the measurements you are evaluating in your goal.
|Wizard map - Goal measured per time interval||
The Service Level Agreement Wizard contains:
|See also||Service Level Agreements Overview|
User interface elements are described below (unlabeled elements are shown in angle brackets):
The thresholds for your goal. If you defined load criteria, enter thresholds for each range of values.
Note: If the maximum threshold value is exceeded during a particular time interval during the run, Analysis displays an SLA status of Failed for that time interval.
|Apply to all
(Average Transaction Response Time goal only)
To apply one set of threshold values to all transactions selected for the goal, enter the threshold values in this table and click Apply to all transactions. These values are applied to all the transactions in the Thresholds table at the top of the page.
Note: Threshold values for selected transactions do not have to be the same. You can assign different values for each transaction.
|Selected Measurement||The measurement selected for the goal.|