Configure Release Control for the integration
This topic describes the tasks that must be performed to configure Release Control for integration.
Note: For more information about the steps in this procedure, see the Installation and Administration Guide.
Before you begin
Before you begin the configuration, you should verify that web services are enabled for use with PPM.
To verify that web services are enabled for use:
Stop the PPM Server.
server.conffile located in the
Verify that the ENABLE_WEB_SERVICES parameter is set to
Run the kUpdateHtml.sh script. For details, see kUpdateHtml.sh.
Restart the PPM Server.
Configure the PPM web services adapter
To establish integration, you must configure the PPM web services adapter in Release Control to convert change requests that come from PPM to generic requests that Release Control can process.
To configure the PPM web services adapter:
Configure the PPM web services connector settings as described in the Release Control Installation and Configuration Guide.
Note: Before version 7.0, PPM was known as Mercury IT Governance Center or ITG. Release Control software and documentation might still refer to PPM as IT Governance Center or ITG.
<request-type level="2">,set the
requestTypeNameto the name of the PPM request type representing a PPM change, for example, ALM - Request for Change (RFC), and set the
parentRequestTypeNameto the value of the
requestTypeNamein step 2.
Refer to documentation for Release Control and contact Release Control Support as necessary.