Placing Your XML Files in the Correct Locations

To deploy the toolkit support set that you create, you must place the XML files in specific locations within the UFT One installation folder. The following table describes the appropriate location for each of the toolkit support files:

File

Location

Test Object Configuration file

  • <UFT One installation folder>\dat\Extensibility\Delphi

  • <UFT One Add-in for ALM installation folder>\dat\Extensibility\Delphi

    (Optional. Required only if the folder exists, which means the UFT One Add-in for ALM was installed independently from the ALM Add-ins page and not as part of the UFT One installation.)

Toolkit Configuration file

<UFT One installation folder>\dat\Settings

Icon files for custom test object classes (optional)

The file can be a .dll or .ico file, located on the computer on which UFT One is installed, or in an accessible network location.

Recommended location: <UFT One installation folder>\dat\Extensibility\Delphi\Toolkits\<custom toolkit name>\res

Specify the location in the test object configuration file.

Help files for the test object classes (optional)

Must be a .chm file, located on the computer on which UFT One is installed.

Recommended location: <UFT One installation folder>\dat\Extensibility\Delphi\Toolkits\<custom toolkit name>\help

Specify the location in the test object configuration file.

Note: In the test object configuration file, you can specify these locations using relative paths. For more information, see the UFT One Test Object Schema Help