Select Configuration Mode Page (Stingray Support Configuration Wizard)

This wizard page enables you to select a configuration mode—either automatic or manual—and to create a diagnostic log file, when needed.

This wizard page opens if you selected the Run-time Agent option in the Support Mode Selection Page.

Important information
  • General information about this wizard is available here: Stingray Support Configuration Wizard.

  • If your Stingray application project is already compiled with an earlier version of the Stingray Add-in agent, your project already contains the required support code. However, it is strongly recommended to remove the previous agent files and to recompile your project with the new Stingray Add-in agent included with this add-in.

Wizard map

Welcome Page > Support Mode Selection Page > Add Support Code Page > (Select Configuration Mode Page) > (Manual Configuration Mode Page) > (Automatic Configuration Mode Page) > (Detected Stingray Components Page) > (Finish Page) > (Detection Failure Page)

See also

Set up Stingray object support

User interface elements are described below:

UI Elements


Automatic configuration

Instructs the wizard to configure Stingray support automatically according to the detected MFC DLL and the version of Stingray business components used in your application.

Manual configuration

Enables you to configure Stingray support manually by specifying the MFC DLL and Stingray business component version used in your application. This is useful, for example, if your application is statically linked to the Stingray libraries.

Create wizard configuration log file

Creates a diagnostic log file.

Select this check box if, at any time, you encounter problems with the Stingray Add-in.

If you contact Software Support for assistance, you may be asked to provide this log file for diagnostic purposes.